Natural gas conversion must be performed only by your natural gas provider or
service company.
Attempting to perform the natural gas conversion yourself is not
safe and may result in property damage, serious bodily injury or death.
NATURAL GAS CONVERSION
!
DANGER & WARNING
P456-776B/T
Page 10 of 12
1. Locate the control and igniter panel. Make sure the control
knob is in the “OFF” position. See Figure 8.Open the tank door
and open the tank valve all the way.
2. Push in the igniter button. You will hear a slight clicking
sound. With the igniter button pushed in, push and turn the
control knob to the “ON” position. The fire should light within
a few seconds. Once the flame is lit, release the igniter button
and continue to hold the control knob in for 10 to 15 seconds.
Release the control knob. The control knob should pop back out
and the fire should remain lit. Note: If the fire does not light, turn
the knob to the “OFF” position and wait five (5) minutes before
trying again.
3. To turn down the flame, push the control knob in slightly and
turn to the Medium (medium flame) or Low (small flame).
4. To shut down the fire pit, turn the control knob to
the “OFF” position and turn off the tank valve
LIGHTING INSTRUCTIONS
CONTROL KNOB
IGNITOR
(1.5 V)
Installer AAA
compartiment
de la batterie (-)
premier côté
Allumeur
(
)
1 5 V
.
.
AAA BATTERY
COMPARTMENT
INSTALL - SIDE
FIRST
( )
OFF
ON
HIGH
MEDIUM
LOW
IGNITER BUTTON
Figure 8
P456-776B/T
Prior to turning gas on and attempting to light the appliance, make sure the appliance is outside,
in a well ventilated area and free of any debris and is not in contact with or near any people, animals,
materials or structures. Failure to adhere to the above instruction may result in property damage,
serious bodily injury or death.
IMPORTANT, FAILURE TO CAREFULLY READ, UNDERSTAND AND FOLLOW EVERY PART OF THIS
DOCUMENT MAY RESULT IN PROPERTY DAMAGE, SERIOUS BODILY INJURY OR DEATH. DO NOT
ATTEMPT TO LIGHT THE APPLIANCE IF YOU DO NOT UNDERSTAND OR CANNOT FOLLOW ANY PART
OF THIS DOCUMENT. THOROUGHLY INSPECT THE APPLIANCE BEFORE ATTEMPTING TO LIGHT TO
ENSURE PROPER ASSEMBLY AND THAT THE ENTIRE APPLICANCE IS IN GOOD WORKING ORDER
AND IS FREE OF ANY GAS LEAKS. IF YOU NOTE ANY LEAKS, IMPROPER ASSEMBLY OR ANY
DAMAGE TO THE APPLIANCE DO NOT LIGHT THE APPLIANCE AND IMMEDIATELY CONTACT A
QUALIFIED SERVICE TECHNICIAN. FAILURE TO DO SO MAY RESULT IN PROPERTY DAMAGE,
SERIOUS BODILY INJURY OR DEATH"
!
!
