Signamax Connectivity System 065-9066
www.signamax-us.com
www.signamax-eu.com
PREFACES
PREFACES
PREFACES
PREFACES
0.1
0.1
0.1
0.1
About This Manual
About This Manual
About This Manual
About This Manual
This manual is designed to assist users in using GSM Gateway. Information in this document
has been carefully checked for accuracy; however, no guarantee is given as to the correctness of
the contents. The information contained in this document is subject to change without notice.
0.2 Copyright Declarations
0.2 Copyright Declarations
0.2 Copyright Declarations
0.2 Copyright Declarations
Copyright 2007 Telephony Corporation. All rights reserved. This publication contains
information that is protected by copyright. No part may be reproduced, transmitted, transcribed,
stored in a retrieval system, or translated into any language without written permission from the
copyright holders.
0.3 Trademarks
0.3 Trademarks
0.3 Trademarks
0.3 Trademarks
Products and Corporate names appearing in this manual may or not be registered tradem
arks or copyrights of their respective companies, and are used only for identification or ex
planation and to the owners’ benefit, without to infringe.
0.4 Safety Instructions
0.4 Safety Instructions
0.4 Safety Instructions
0.4 Safety Instructions
The most careful attention has been devoted to quality standards in the manufacture of the
Gateway. Safety is a major factor in the design of every set. But, safety is your responsibility too.
Use only the required power voltage. Power Input: AC 100-240V, 50-60Hz
To reduce the risk of electric shock, do not disassemble this product. Opening or removing
covers may expose the Gateway to hazardous voltages. Incorrect reassembly can cause
electric shock when this product is subsequently used.
Never push objects of any kind into the equipment through housing slots since they may
touch hazardous voltage points or short out parts those could result in a risk of electric
shock. Never spill liquid of any kind on the product. If liquid is spilled, please refer to the
proper service personnel.
Use only Unshielded Twisted Pair (UTP) Category 5 Ethernet cable to RJ-45 port of the
Gateway.
