Getting Started |
Connecting Your Signal Hound VGS25
2
The easiest way to install the drivers post application installation is to run the correct driver installer in
the application directory. Select the proper installer based on the type of PC you have (32/64-bit) and run
the driver installer as administrator (right-click, run as administrator). A console will appear to let you
know if the installation was successful.
If the drivers still not install correctly, contact Signal Hound.
CONNECTING YOUR SIGNAL HOUND VGS25
With the software and device drivers installed, you are ready to connect your device. The supplied USB
cable should be connected into your PC first followed by your device.
The first time you connect the device to your PC, the PC may take a few seconds to recognize the device
and update any drivers. Wait for this process to complete and the PC to recognize the device before
launching the software. You may need to reboot your computer after driver installation.
When your device is ready, the back-panel LED should show a constant green color.
RUNNING THE SOFTWARE
With the software installed and the device recognized you can run the software. You can do this through
the desktop shortcut or through the VSG25.exe file found in the installation directory.
3
Getting Started
Launching the VSG25 software brings up the user interface (UI). This section describes the UI in detail
and how you can use the UI to control your Signal Hound vector signal generator.
Below is a picture of the software with all major areas of interest labeled:
Summary of Contents for VSG25
Page 1: ...VSG25 Software Manual...
