SIGMATEK 20-004-313, Operating Manual

Page: 19 / 56

S-DIAS CPU MODULE CP 313
29.05.2020 Page 17
6.1 Status LEDs Interface Part
Run green ON from activation of the voltage supply until processing of the
autoexec.lsl
when the application is running (except when controlled differently
via the application )
BLINKS In the CLI, while processing the autoexec.lsl until the application is
running
During installation of the operation system (starting from OS
version 09.03.054)
OFF when error occurs
reset-state
Permanent from power on: microSD card error
(1)
can be set from the application (ON, BLINKING, OFF)
Status yellow OFF during start process
during RUN status (application running)
when error occurs or reset
Permanent from power on: microSD card error
(1)
can be set from the application (ON, BLINKING, OFF)
Error red
BLINKS when an error or reset occurs
OFF
during start process
during RUN status (application running)
Permanent from power on: microSD card error
(1)
can be set from the application (ON, BLINKING, OFF)
VARAN Link
green ON connection between the two PHYs made
BLINKS VARAN In of the primary client has no link
VARAN Active yellow
ON data is exchanged over the VARAN bus
Ethernet Link green ON connection between the two PHYs made
Ethernet Active yellow ON data is exchanged over the Ethernet bus
EtherCAT Link green ON connection between the two PHYs made
EtherCAT Active yellow ON Data is exchanged over the EtherCAT bus
(1)
If the microSD card is not properly inserted or if data (operating system, application) is faulty, the RUN, STATUS
and Error LEDs do not light up after switching on the power supply. The DC OK LED lights up permanently.