Page
15
OSD Menu
The dome system has 4 alarm inputs and 2 alarm
output. (optional function). When an alarm is re-
ceived, an input signal to the dome triggers the user
defined action (such as presets, patterns, etc.), and at
meantime the alarm output signals is activated.
ALARM NO.: Move the cursor to ALARM NO..
Click Iris + to enter and click up or down button to
select the alarm input no. (Channel 1 and Channel 2)
INPUT STATE: Set the alarm contact status. There
are two input states, OPEN and CLOSE.
ALARM MODE:
ACTION: Set the alarm action:
OFF: alarm function is deactivated.
ON: alarm function is activated.
AUTO: auto alarm function will be activated and
deactivated between start time and stop time.
ACTION: Set the alarm action:
None: (default) No action
Preset: Dome goes to preset. (Default as Preset 1)
Scan: Dome starts auto scan (Default as auto scan 1)
SEQ: Dome runs auto cruise (Default as auto cruise
1)
Pattern: Dome runs pattern (Default as Pattern 1)
ALARM OUT: Move the cursor to ALARM OUT.
Click IRIS + to enter and click up or down button to
select alarm output channels among “OFF”
“OUTPUT1” “OUTPUT2” “ALL”, which is used to
set linkage alarm output switch after receiving effec-
tive alarm input signals.
RESET DELAY: Move the cursor to the ALARM
OUT. Click IRIS + to enter and click up or down
button to select reset delay among “10SEC” “30SEC”
“1MIN” “5MIN” “10MIN”.Which mean the time of
the speed dome from detecting alarm signals to alarm
reset and return to normal. The setting is valid under
AUTO ALARM MODE.
MAIN
INFORMATION
( DOME SETTINGS )
MOTION
RESTART
FACTORY
EXIT
DOME SETTINGS
（IR LED）
( WIPER )
( IDLE )
( ALARM )
(PRIVACY MASK)
(ADVANCED)
(OTHERS)
BACK EXIT
ALARM NO.:1
CONTACT:NO
ALARM MODE:OFF
ACTION:NONE
ALARM OUT:OFF
RESET DELAY:10SEC
BACK EXIT
ALARM SETTING
3.2.4 ALARM
OSD Menu
