SIGLENT TECHNOLOGIES SDS2000X-E Series, User Manual, Page: 48 / 222

SIG L ENT
22
SDS2000X-E
User Manual
Enable the Channel
The oscilloscope provides 2 analog input channels and provides a vertical control system
for each channel. As the vertical system setting methods are the same, this chapter takes
CH1 as an example to introduce the setting method of the vertical system.
Connect a signal to the CH1 channel input connector; and then press the
CH1 button in
the vertical control area (Vertical) on the front panel to enable CH1.
The channel setting menu is displayed at the bottom of the screen and the channel label
at the right side of the screen. The information displayed in the channel label is related to
the current channel setting.
After the channel is turned on, modify the parameters such as the vertical scale, the
horizontal time base and the trigger mode according to the input signal to make the
waveform display easy to observe and measure.
Note: If multiple channels are turned on at the same time, you should view the channel
menu before turning off the channel. For example: If Channel 1 and Channel 2 are
turned on and the oscilloscope displays the Channel 2 menu, press
CH1 to display
the Channel 1 menu, then press CH1 again to turn off Channel 1.