START-UP PROCEDURE
After installation is complete, perform the following start up procedure:
1.
Completely open discharge connection (ball valve located on the handle)
2.
Turn both of the compressor heads on. The compressor will automatically turn off when the
pressure gauge shows maximum pressure around 115 psig.
3.
The compressor will automatically restart when the pressure gauge shows pressure around 85
psig.
Your EAGLE Compressor is ready to operate. Check if there is any leakage. You can do this by filling
the compressor up all the way (115psi) Do not use any compressed air. Wait about 15 minutes and
make sure the pressure has not dropper more than 5 psi. In case there is any loss, eliminate it before
proceeding.
12