Please contact 570-385-4733 or [email protected] for further assistance
11
Sierra
OUTDOOR DESIGNS
24 inch Trash Cabinet
Assembly - continued
7
8
Parts needed for 24 inch Trash Cabinet
2
Side panels
SP3626V3
*
12 ButtonSoc Cap screws L1-0002
Short Arm Hex Key
Attach the side panels.
To attach side panels, place one of the side panels on one side
and screw in all 6 ButtonSoc Cap screws in by hand on the
inside of the panel and post. (see fig. 9) NOTE: The panels will
only go on one way as the holes match up with the post and
panel.
**
Once all the screws are in place, go back and tighten them all
with the Short Arm Hex key. Repeat for the other side panel.
NOTE: If using a filler panel for connecting to another unit,
see Appendix A at the end of these instructions.
Figure 9
Front
** If you have a left unit – the finished panel goes to the left. If you have
a right unit, the finished panel goes on the right. If you have a center unit,
filler panels go on both the right and the left.
* Part numbers are for stainless steel panels. If you have faux stone
or filler panels, you can find part numbers on page 6.
Front
Parts needed for 24 inch Trash Cabinet
4
Adjustable legs
L2-0001
Attach the adjustable legs to the bottom panel.
Lean cabinet on its side, if necessary, being careful not to
scratch the surface. Screw in 1 of the 4 legs to the bottom
panel into the hole by turning it clockwise. (see fig. 10)
Repeat for the other 3. Adjust the bottom part of the leg by
turning counter clockwise until the unit is level. (see fig. 11)
NOTE: It is advised to start at the highest point of where the
legs touch the surface for leveling.
Figure 11
Figure 10
Front
