Sierra Wireless DART 200, User Manual

Page: 174 / 206

DART 200 CDPD Modem User’s Guide F DART AT Command Set
Sierra Wireless, Inc. F-30
Table F-7 Service Provider commands beginning with dash (-)
-L Lock on a Specific Channel
Permits the DART to override normal Radio Resource Management functions and lock itself on a
specific channel.
This is useful at Trade Shows where exhibitors are often requested to operate on a specific channel. It is
also helpful during initial testing when it sometimes is necessary to seek out a specific channel.
The modem continues to operate on the assigned channel until the lock is removed, changed to another
channel, or bit 2 in S-Register 60 is turned off.
Format:
AT-L<n>
Locks the modem on channel <n>
AT-L-
Releases the channel lock
Result codes:
OK
Valid argument
ERROR
Invalid argument
NOT ENABLED
Modem is not in service provider mode
-R Software Reboot of the DART
Reboots (restarts) the DART. It is equivalent to power cycling the modem. Use this command to
activate changes in the modems operating parameters such as
\J, \N, *A, *L, IP Address, and CDPD
operating mode (SReg95).
Format:
AT-R
Reboot (restart) the DART
Result codes:
NOT ENABLED Modem is not in service provider mode
-V View Radio Resource Management Data
Displays the current value of pertinent Radio Resource Management Data. Some of this data are the
Carrier operating (XID) parameters to be used by the modem; other data is statistical accumulations of
channel acquisition and channel hopping data that is accumulated between modem resets.
NOTE:
To avoid clearing the accumulated statistical data you must not reset the modem.
Format:
AT-V2
View channel stream, quality, and access parameters
AT-V3
View Adjacent Cell Configuration Information
AT-V4
View channel acquisition statistics
AT-V5
View channel hopping statistics
Result codes:
ERROR
Invalid Argument
NOT ENABLED
Modem is not in service provider mode