3600I
Page: 31
3.2 SAFETY
PRECAUTIONS
After powering-up, the detector requires almost no attention in order to function
properly, but the following should be noted:
•
Follow the instructions in this guide and refer to the drawings and specifications.
•
Do not expose the detector to radiation of any kind unless required for testing
purposes.
•
Do not open the detector housing, while power is applied.
•
Do not open the electronic compartment. This part should be kept closed at all
times and only opened in the factory. Opening the electronic component side
invalidates the warranty.
•
You should only access the wiring compartment to wire or remove the detector or
access RS485 terminals for maintenance.
•
Disconnect or disable external devices, such as automatic extinguishing systems
before carrying out any maintenance.
3.2.1 DEFAULT
FUNCTIONS
SETTINGS
Table 20 lists the default function configuration supplied with the detector.
Table 20: Default Function Values
Function
Value
Notes
Sensitivity 30
Alarm Delay
A
Anitflare
Alarm Latch
No
Auxiliary Relay
No
In wiring options 1, 2, 3 the Auxiliary Relay is not
available. This function is not used.
Automatic BIT
Yes
Alarm BIT
No
Auxiliary BIT
No
In wiring options 1, 2, 3 the Auxiliary Relay is not
available. This function is not used.
EOL
No
In wiring options 1, 2, 3 the Auxiliary Relay is not
available. This function is not used.
Heat Mode
Auto
Heat On
41°F (5°C) The detector starts heating the window for any
temperature below this value (in degrees
Celsius).
•
In order to change the default function use:
•
P.C with Sierra Monitor software, refer to Manual 777050 for instructions.
•
Handheld unit, refer to Manual 777060 for instructions.
•
USB cable with 485 converter (1 m) part number 794079-5.
•
HART Protocol, refer to Manual 777030 for instructions.
