6
CAUTION: Upon initial use, please hold trigger to allow the water to fl ow thru
the system for approximately 30 seconds to prime the unit.
WARNING: ON SURFACES THAT HAVE BEEN TREATED WITH WAX, THE WAX
MAY BE REMOVED BY THE HEAT AND STEAM ACTION. DO NOT USE ON
UNSEALED WOOD FLOORS OR LET UNIT STAND ON ANY WOOD FLOOR FOR AN
EXTENDED PERIOD OF TIME. THIS MAY CAUSE THE WOOD GRAIN TO RISE.
IT IS RECOMMENDED THAT A SECTION BE TESTED IN AN ISOLATED AREA OF
THE FLOOR. IT IS ALSO RECOMMENDED THAT YOU CHECK THE USE AND CARE
INSTRUCTIONS FOR CLEANING FROM THE FLOOR MANUFACTURER TO ENSURE
STEAM CLEANING IS ACCEPTABLE FOR YOUR FLOOR.
7) Slowly pass over surface to be cleaned while pressing trigger to emit steam. It is
recommended to sweep or vacuum
fl
oor prior to using the steam mop.
CAUTION: To sanitize an area of your fl oor, leave the steamer over the area for
a minimum of 8 seconds, but no longer than 15 seconds. Leaving the steamer
in a stationary position for a longer period than recommended may cause
build up of pail residue. This residue can be removed by using a decalcifying
product or with a few drops of vinegar.
8) When steamer stops emitting steam, after approximately 15 to 20 minutes of use,
simply remove the water tank, re
fi
ll, and continue cleaning.
WARNING: NEVER RUN THE STEAMER WITHOUT WATER.
9) When you
fi
nish cleaning, unplug power cord from outlet. Be sure to empty water
tank and carefully remove cloth pad from steamer head. Store the unit upright in a
dry area or hang it by the storage hook.
CAUTION: The cloth pad may be very hot.
Carpet Glider
10) Lay carpet glider on the
fl
oor in an upright position with the triangular
fl
at surface
facing downward. Place steam mop head on top of glider as illustrated below.
IMPORTANT: The carpet glider is not designed to be fixed to the floor head
for safety reasons including preventing burns. It is designed for use on soft
carpet areas only, not for hard fl oor surfaces.
10
