ASSEMBLY AND USE
1) Set press on a
fl
at, level surface.
2) Turn Locking Knob dial to “unlock” and lift the Pressing Handle to open the press.
The press will automatically stay in lifted position.
3) Before plugging in the press,
fi
ll the Water Tank using the Water Container provided.
Slide the Water Tank forward and pouring the water into the holes of the tank. When
fi
nished, slide the tank back into place. Water is only necessary when using Steam
Burst Button.
NOTE: When filling the Water Tank, distilled water is preferred, but not
necessary.
NOTE: The Water Tank is not removable. It is designed to store any left over
water from use. Do not attempt to force it free.
4) Plug in and press Power On/Off Button/Switch. A Power Light (Red) will appear (Yellow
for Expresso only). Be sure Pressing Plate is in open position when unit is initially
turned on.
5) Select desired temperature and allow press to heat before use. Turn Temperature
Control Dial (Expresso model only) or use Fabric Temperature Selection arrows
(Empressa and Elite models) to choose fabric setting. It may take a few minutes to
reach chosen temperature when decreasing or increasing settings.
NOTE: It takes approximately 4 minutes for the press to reach the Linen
temperature.
Warning: During initial use or after a long period of time without use, press
the Steam Burst Button continuously for several seconds to clear Pressing
Plate of residual water or calcium buildup in system before use.
FABRIC
NYLON
SILK
RAYON
WOOL
COTTON
LINEN
100
O
C
130
O
C
140
O
C
160
O
C
200
O
C
210
O
C
212
O
F
266
O
F
284
O
F
320
O
F
392
O
F
410
O
F
STEAM
NO
NO
NO
YES
YES
YES
7
