counterweight easel assembly instructions
3 of 5
Raise the easel assembly and connect back
supports with 2 angle adjustment knobs with
washers. The back supports fit inside easel
assembly. The knobs thread into the back
supports through the angle adjustment slots.
NOTE: This step is much easier with two people.
Attach the bottom canvas holder using 4 long
connector bolts. Make sure the round clamping
disks are in place.
NOTE: It will be necessary to bend the wire to
the side to insert 2 of the bolts.
Attach the top canvas holder and
optional lower canvas holder.
Slide canvas holder onto center mast.
TIP: the canvas holder guide blocks can be
adjusted slightly by loosening and tightening
the guide block bolts.
TIP: The optional lower canvas holder
is useful for holding smaller paintings.
It also features clips for holding panels.
long connector
bolt 4
manufactured by craftech international inc.
www.siennapleinair.com
7042 Kearny Drive, Huntington Beach, CA 92648 tel: 714-847-8215 [email protected]
