Siemens Industry, Inc.
Building Technologies Division
P/N 315-048670-11
6
S1 Input Power Select:
This switch consists of three individual switches which must
all be set in the same position. Use S1 to select the source of voltage input to power
the ZIC-8B.
BP Power
(Backplane Power) indicates that the input is derived from the
backplane of the CC-2/CC-5 and
EXT Power
(External Power) indicates that the input
is derived from E5/E11 terminal of the CC-2/CC-5, normally connected to non-power
limited output of the PSC-12/PSX-12. It is important to take into account the source
of the voltage during battery calculations.
P3, P4, P5, P6 Shunt Headers, NAC Input Supervision Enable:
These headers
select the NAC input zone supervision. If usage application is set for speaker func-
tion, place the shunt jumpers of the corresponding zone between 1—2 and be-
tween 5—6, otherwise place the shunt jumpers between 2—4 and 3—5.
P3 selects NAC input supervision for Zone 1
P4 selects NAC input supervision for Zone 2
P5 selects NAC input supervision for Zone 3
P6 selects NAC input supervision for Zone 4
ZIC-2C
If the ZIC-2C will be used for two channel capability, install it now on the
ZIC-8B PC board. Connect the ZIC-2C PC Board to the ZIC-8B by lining up the
connector on the ZIC-2C to the receptacle on the ZIC-8B. Gently insert the connector
into the receptacle being careful not to bend the connector. Refer to Figure 2 for
positioning the ZIC-2C on the ZIC-8B.
WIRING
Remove all system power before installation, first battery then AC. (To power up,
connect the AC first, then the battery.)
All field wiring to the ZIC-8B is connected
to the terminal blocks of the CC-5/CC-2
card cage slot in which it is installed (refer
to Figure 3).
To Connect External Wiring
1.
Loosen the screw of the terminal
by turning it counterclockwise.
2.
Insert the wire into the side of the
terminal block
3.
Tighten the screw of the terminal
block by turning it clockwise.
The top terminals (1 through 8 and 9
through 16) are connected to the notifica-
tion appliance devices such as bells, horns,
strobes, speakers, etc. Each zone has two
terminal connections: (+) and (-). These
terminals are power limited.
The bottom terminals (17 through 24) are
connected to the input power source of the
NAC devices. Each zone has a (+) terminal
and (-) terminal. These terminals are not
power limited.
Figure 3
Wiring The 24VDC Power Lines To
The ZIC-8B Slot In The CC-5/CC-2
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
+
+
-
-
+
+
-
-
+
+
-
-
+
+
-
-
OUTPUTS SHOWN IN ACTIVE STATE
+
-
+
-
+
-
+
-
17
18
19
20
21
22
23
24
ZONE 1
ZONE 5
ZONE 1&2
INPUT
ZONE 2
ZONE 6
ZONE 3
ZONE 7
ZONE 4
ZONE 8
ZONE 3&4
INPUT
ZONE 5&6
INPUT
ZONE 7&8
INPUT
ONE SLOT OF CC-5
6
3
2
1
5
4
(SET FOR
NAC INPUT)
