Siemens WTT568 Series, Operating And Installation Instructions

Page: 106 / 430

Installation | EN
Auto install is successful if the gateway has received all required networks defined in the S GCP.
If the conditions of the check are fulfilled, the buzzer generates a short tone, the
LED flashes green and the "INSTALL" + "OK" message appears in the display.
The gateway can now be mounted on the wall.
The "INSTALL" + "OK" message is shown in the display for 60 minutes. The gateway is then placed in sleep mode.
The gateway can also be placed in sleep mode manually by a long press of the function key.
If the S GCP contains tasks for the gateway, it does not go into sleep mode until they have been processed. If the
function key is pressed for a long time during this time, the message „busy“ appears in the display.
Failed Auto Install
Auto install has failed if the gateway has not received the required networks defined in the S GCP.
If automatic installation of the WTT568../WTX568.. has failed, the buzzer generates a short
tone, the LED flashes red and the "FAILED" message is shown in the display for 60 minutes.
The gateway is then placed in sleep mode. The gateway can also be put into sleep mode
manually with a long press of the function key.
Reasons for failure of the installation can be:
•
poor radio reception
•
the conditions of the validity check in the S GCP were not fulfilled.
In this case we recommend the following procedure:
– Change the position within the building to achieve better radio conditions and restart the Auto Install.
– Contact the technical customer service department or your supplier to have the configuration of the gateway
checked and corrected.
Cancel Auto Install
1. Press the function key for 2 seconds.
2. Confirm the message "ABORT" by pressing the function key again for 2 seconds.
P
The gateway is reset to sleep mode.
19.04.2022 106