Siemens WTT568 Series, Operating And Installation Instructions

Page: 104 / 430

Installation | EN
The gateway now searches for network nodes within its radio range. All detected and captured networks are
shown consecutively in the display with the relevant information, each for 3 seconds. The scanning process lasts 5
minutes. During the entire scanning process the LED flashes green and the information on the captured networks is
displayed alternately (display loop).
Example:
During the scanning process the radio signal strength of the networks is updated continuously. For example,
while the display loop is running, a node with a better signal strength may have been found for a network already
displayed with a certain signal strength. This network is shown with the better signal strength the next time it is
displayed. The scanning process ends after 5 minutes.
C
B
A
(A) Consecutive number of the captured networks (C) Radio signal strength
(B) Network ID
Completion of the Auto scan
The buzzer generates a short tone and the scanning result is shown in the display. In this
example the gateway has captured a total of 4 networks within its radio range and the radio
connections for communication over the mobile phone network are fulfilled.
All captured networks are then shown consecutively in the display, each for 3 seconds. Short press the function key
to forward the display levels manually.
Example:
60 min or manually switch off
3 sec or
short key press
3 sec or
short key press
3 sec or
short key press
3 sec or
short key press
At the same time the gateway sets up a link to the S GCP and transmits the results of the network scan to the
S GCP. The display loop runs for 60 minutes. The gateway is then placed in sleep mode. The gateway can also be
placed in sleep mode manually with a long press of the function key.
The Auto scan is successful if all expected networks have been captured with at least adequate signal strengths.
The gateway can now be mounted on the wall.
If all expected networks have not been captured with at least adequate signal strengths:
•
Change the position within the building to achieve better radio conditions.
•
Restart the Auto scan.
Cancel Auto scan
1. Press the function key for 2 seconds.
2. Confirm the message "ABORT" by pressing the function key again for 2 seconds.
P
The gateway is reset to sleep mode.
If the scanning process was interrupted twice, the gateway switches to „MANUAL“ mode. The procedure of the
scanning process in this mode is identical to the „NEW“ mode.
19.04.2022 104