Siemens WT45N202GB, User Manual And Installation Instructions

Page: 67 / 84

Troubleshooting
en
67
Fault Cause and troubleshooting
The programme does
not start. You have not pressed
Start/Reload
.
▶
Press
Start/Reload
.
Door is not closed.
1.
Close the door.
2.
Press
Start/Reload
to start the programme.
Childproof lock is activated.
▶
→ "Deactivating the childproof lock", Page 51
Ready In
is activated.
▶
Check whether
Ready In
is activated.
→ "Buttons", Page 26
Laundry is caught in the door.
1.
Open the door again.
2.
Remove any trapped laundry.
3.
Close the door.
4.
Press
Start/Reload
to start the programme.
The detergent drawer has not been pushed in as far
as it can go.
▶
Push the detergent drawer in as far as it will go.
The pump for the intelligent dosing system is blocked.
1.
Switch off the appliance.
2.
Clean the pump unit.
→
"Cleaning the detergent drawer", Page 58
3.
If this indicator appears again, call our after-sales
service.
→
"Customer Service", Page 77
Note:
You can start the washing programme if you de-
activate the intelligent dosing system and dose manu-
ally.
→
"Buttons", Page 26
The door cannot
be opened.
Rinse Hold
⁠ is activated.
▶
Continue the programme by selecting
Spin
or
Drain
and pressing
Start/Reload
.
→ "Resuming the programme when the programme
status is Rinse Hold", Page 50
The temperature is too high.
▶
Wait until the temperature has dropped.
▶
→ "Cancelling the programme", Page 50
Water level is too high.
▶
Start the
Drain
programme.
Power failure.
www.devicemanuals.eu