en
Installation and connection
14
During installation ensure that:
■
The dryer is placed on a clean, level
and firm surface,
■
The mains plug can be accessed at
all times,
■
The air inlet on the dryer is kept clear
and there is sufficient ventilation,
■
The area around the dryer is kept
clean and
■
The dryer is levelled using the
threaded feet.
Note:
Check the alignment of the
appliance with a spirit level and
correct if necessary. Change the
height by turning the appliance feet.
All appliance feet must stand firmly
on the ground.
Incorrect alignment may cause high
noise levels, vibrations and improper
movement of the drum.
Note:
If in doubt, have the appliance
connected by a specialist.
Changing the condensation
drain
Notes
■
The condensation from the dryer can
either be discharged into
the condensate container or drained
off via a connection to the waste-
water system. The factory setting is
for the condensation from the dryer
to be discharged into
the condensate container.
■
If the condensation drain is installed,
residual water remains in
the condensate container because
of the dryer's self-cleaning function.
Change the condensation drain as
follows:
1.
Remove the accessory from
the dryer drum.
2.
Delivery status of the dryer. The hose
for discharging the condensation
into the condensate container is
secured to the connecting piece.
3.
Disconnect the hose from
the connecting piece and move it
into the "parked" position.
4.
Remove the drain hose from
the accessory and secure it to the
empty connecting piece.
Summary of Contents for WT43W530EE
Page 39: ...6 ...
