en
Operating the appliance
40
1
Operating the
appliance
Operating the appliance
Preparing the washing
machine
Note:
The washing machine
must be
correctly installed
and
connected
.
1.
Connect the mains plug.
2.
Turn on the tap.
3.
Open the door.
4.
Check that the drum is completely
drained. Drain if necessary.
Switching on the appliance/
selecting a programme
Press the
#
button. The appliance is
switched on.
The
Cottons
Î
programme set at the
factory is then always displayed.
You can use this programme or select a
different programme. The programme
selector can be turned in either
direction.
Note:
If you have activated the
childproof lock, you must deactivate it
before you can set a programme.
The indicator light on the programme
selector lights up and the
default
programme settings
for the selected
programme appear in the display panel.
■
Temperature
■
Spin speed
■
The maximum load and the duration
of the programme (alternately)
■
The indicator light for the i-Dos
settings, if intelligent dosage has
been selected
■
Information on water and energy
consumption
In appliances with a
drum light
:
The drum is lit after switching on the
appliance, after opening and closing the
door and after starting the programme.
The light switches off automatically.
Placing laundry into the drum
:
Warning
Danger of death!
Items of laundry pretreated with cleaning
agents that contain solvents, e.g. stain
remover/cleaning solvent, may cause an
explosion after being loaded into the
washing machine.
Hand-rinse these items of laundry
thoroughly beforehand.
Notes
■
Mix items of laundry of varying sizes.
Laundry items of different sizes
distribute themselves better during
the spin cycle. Individual laundry
items may cause an unbalanced
load.
■
Observe the maximum specified
load. Overfilling adversely affects the
washing result and promotes
creasing.
1.
Unfold presorted laundry items and
place them in the drum.
2.
Make sure that no items of laundry
are trapped between the door and
the rubber seal, and close the door.
The
Ü
button indicator lamp flashes and
the programme settings appear in the
display panel.