Siemens WM14Y540EE, Instruction Manual

Page: 38 / 60

38
Faults, what to do?
Faults Cause/Remedy
Water is running out. – Correctly attach/replace drainage hose.
– Tighten screw-fitting on the supply hose.
Water not flowing in.
Detergent not
washed in. – Inicio /Carga ( Start /Reload)
Ü
not selected?
– Tap not open?
– Filter blocked? Clean the filter.
– Supply hose kinked or jammed?
Washing-machine
door cannot be
opened. – Safety function active. Stop programme?
–
Flot
$
(without final spin) selected?
– Can be opened via emergency release only?
~
Page 36
Programme does
not start. – Inicio /Carga ( Start /Reload)
Ü
or Terminado en/em (Finished
in)
time selected?
– Door closed?
– Childlock active? Deactivate.
Detergent solution is
not drained. – Flot
$
(without final spin) selected?
– Clean the drain pump.
~
Page 33
– Clean outlet pipe and/or drainage hose.
Water not visible in
the drum. Not a fault – water below the visible area.
Spin result not satis-
factory.
Washing wet/too
damp. – Not a fault – unbalanced load detection system has stopped the
spin cycle, washing unevenly distributed.
Distribute small and large items of washing in the drum.
– Menos (Less Ironing)
æ
selected?
– Too low speed selected?
~
Page 22
Spin cycle actuated
several times. Not a fault – unbalanced load detection system adjusts imbalance.
Residual water in the
dispenser for care
product. – Not a fault – effect of the care product not impaired.
– If required, clean insert.
~
Page 33
Odour formation in
the washing
machine. Run Algodón (Cottons) 90 °C programme without washing.
Use standard detergent.
Loud noise forma-
tion, vibrations and
“wandering” during
spin cycle. – Appliance aligned?
Align the appliance.
~
Page 51
– Appliance feet fixed?
Secure appliance feet.
~
Page 51
– Transportation safety devices removed?
Remove transportation protection devices.
~
Page 46