Siemens WM14VG43, User Manual And Installation Instructions

Page: 45 / 60

Troubleshooting
en
45
Fault Cause and troubleshooting
"E:30 / -80" The pump cap is not fully screwed in.
▶
Ensure that the pump cap is screwed in all the way
into the appliance. The handle on the pump cap
must be in a vertical position.
"E:36 / -25 / -26" Drain pump is blocked.
▶
→ "Cleaning the drain pump", Page 40
"E:38 / -25 / -26" Drain pump is blocked.
▶
→ "Cleaning the drum", Page 39
if the fault is displayed again,
▶
→ "Cleaning the drain pump", Page 40
Inlet opening of the rubber gasket is blocked.
▶
→ "Cleaning the intake opening in the rubber gas-
ket", Page 43
All other error codes. Malfunction
▶
Call the after-sales service.
→
"Customer Service", Page 53
Water cooling To protect the wastewater pipes, the hot detergent
solution is cooled before being drained.
▶
Wait until the detergent solution has cooled down.
"E:30/-20" Solenoid valve defective.
▶
Call the after-sales service.
→
"Customer Service", Page 53
Detergent dosage is too high.
▶
Reduce the amount of detergent for the next wash-
ing cycle with the same load.
Additional water is added.
▶
Do not add any extra water to the appliance while it
is operating.
The appliance is not
working. The mains plug of the power cord is not plugged in.
▶
Connect the appliance to the power supply.
The circuit breaker in the fuse box has tripped.
▶
Check the circuit breaker in the fuse box.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other
appliances are working.
The programme does
not start. You have not pressed
Start/Nachlegen
.
▶
Press
Start/Nachlegen
.
Door is not closed.
1.
Close the door.