Positioning and connecting
en
39
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. In
order to remove any water which may
be left over from the test, run the first
washing cycle
without
any laundry.
Notes
■
The washing machine
must be cor-
rectly
installed
and
connected
■
Never use a damaged machine.
Inform your after-sales service.
1.
Check the machine.
2.
Remove the protective film from the
control panel.
3.
Connect the mains plug.
4.
Turn on the water tap.
5.
Close the washing machine door (do
not load any laundry).
6.
Select the
W
Drum Clean
programme.
7.
Open the detergent drawer.
8.
Pour approx. 1 litre of water into
compartment
II
.
9.
Pour standard detergent into
compartment
II
.
Note:
To prevent foaming, only use
half of the amount of detergent
recommended by the detergent
manufacturer. Do not use detergent
for wool or delicates.
10.
Close the detergent drawer.
11.
Press
Start
/Reload
!
.
12.
Switch off the appliance at the end of
the programme.
Your washing machine is now ready to
use.
Transportation
e.g. when moving home
Preparatory work:
1.
Turn off the water tap.
2.
Reduce the water pressure in the
supply hose.
Maintenance – filter in the water
supply
3.
Disconnect the washing machine
from the mains.
4.
Drain the remaining detergent
solution.
Maintenance – detergent solution
pump blocked
5.
Remove the hoses.
Before initial use:
Notes
■
The transport locks
must
be remo-
■
To prevent unused detergent from
flowing straight into the drain during
the next wash: Pour
approximately 1 litre of water into
compartment
II
and select and start
the
0
Spin/
Drain
p
programme (if
only drain cycle is required, set (Spin
speed)
0
on - - - ).
Installing the transport locks:
1.
Remove the covers and keep them
in a safe place.
Use a screwdriver if necessary.
2.
Insert all four sleeves.
Clip the mains cable securely in the
holders. Insert and tighten the
screws.
