Siemens WM10K160IN, Instruction Manual And Installation Instructions

Page: 21 / 40

Operating the appliance
en
21
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
1.
Press Start/
Reload
!
.
2.
Select the other programme.
3.
Press
Start
/Reload
!
. The new
programme starts from the
beginning.
Cancel the programme
Programmes at high temperatures:
1.
Press Start/
Reload
!
.
2.
To cool the laundry: Select
Rinse
.
3.
Press
Start
/Reload
!
.
For programmes at low temperatures:
1.
Press Start/
Reload
!
.
2.
Select
Spin
/
Drain
.
3.
Press
Start
/Reload
!
.
Programme end during rinse
hold
– – –
0
appears on the display panel
and the Start/Reload
!
button indicator
lamp flashes.
To end the programme, set the
programme selector to Spin/Drain or
select a spin speed. Then press the
Start
/Reload
!
button.
Programme end
End
appears on the display panel and
the Start/Reload
!
button indicator
lamp is off.
If the
x
symbol appears on the display
panel, the washing machine has
detected too much foam during the
wash programme and automatically
switched on a rinse cycle to remove the
foam.
Note:
Add less detergent for the next
washing cycle with the same load.
Removing laundry/switching
off the appliance
1.
Open the washing machine door
and remove the laundry.
2.
Set the programme selector to off
position. The appliance is switched
off.
3.
Turn off the water tap.
Notes
■
Do not leave any items of laundry in
the drum. They may shrink in the
next wash or discolour another item.
■
Remove any foreign objects from the
drum and the rubber seal – risk of
rusting.
■
Leave the washing machine door
and detergent drawer open so that
any residual water can dry away.
■
Always wait for the end of the
programme, otherwise the appliance
may still be locked. Then switch on
the appliance and wait for it to
unlock.
■
If the display panel goes off at the
end of a programme, energy-saving
mode is active. To activate the panel,
press any button.