14
Special programmes
retirar pelusas/fios (Fluff Clean)
The drum must be empty.
This programme is designed to clean the drying cycle of any fluff
deposits. The washer-dryer uses the flashing symbol
7
(
Fluff removal
cycle
) in the display panel to show that this programme must be run. The
electronic cycle counter is then automatically reset. The
7
(
Fluff removal
cycle
) symbol goes out after the programme starts.
To run the
retirar pelusas/fios (Fluff Clean)
programme, proceed as
follows:
Make sure that the drum is completely empty and close the door.
Set the programme selector to
retirar pelusas/fios (Fluff Clean)
.
Press the
inicio pausa
(Start/Pause) button.
You can also run the
retirar pelusas/fios (Fluff Clean)
programme at any
time without prompting from the appliance.
'
+centrigug.
0
(Rinse + Spin)
:
An additional rinse cycle with a final spin. If the laundry is to be removed
dripping wet, set the spin speed to
$
(Rinse stop) before starting the
programme
+
+centrifug.
0
(Empty + Spin)
:
Drain the rinsing water following a programme with
$
(Rinse stop)
Turn the programme selector to
+
+centrifug.
0
(Empty + Spin)
.
Set the spin speed to
$
(Rinse stop).
Press the
inicio pausa
(
Start
/Pause) button.
or
Drain
and
spin at the desired spin speed:
Turn the programme selector to
+
+centrifug.
0
(Empty + Spin).
Press the
0
(Spin)
button repeatedly until the desired spin speed is
set.
Press the
inicio pausa
(Start/Pause) button.
