Avoid material damage NL
▶
Make sure that the thread length
on the connection to the water
tap is at least 10 mm.
Water pressure that is too low or too high can
interfere with the appliance function.
▶
Make sure that the water pressure
on the water supply system is at
least 100 kPa (1 bar) and at most
1000 kPa (10 bar).
▶
If the water pressure exceeds the
specified maximum value, a
pressure reducing valve must be
installed between the drinking
water connection and the hose set
of the device.
▶
Do not connect the device to the
mixer tap of a pressureless water
heater or boiler.
Modified or damaged water hoses can
lead to material damage and damage
to the device.
▶
Never kink, pinch, modify or cut
water hoses.
▶
Only use supplied water hoses or
original spare hoses.
▶
Reuse never used water hoses.
Use with contaminated or too hot
water can cause material damage and
damage to the device.
▶
Operate the device only with cold
tap water.
Unsuitable cleaning agents can
damage the surfaces of the device.
▶
Do not use sharp or abrasive
cleaning agents.
▶
Do not use strongly alcoholic
cleaning agents.
▶
Do not use hard scouring or
dishwashing sponges.
▶
Clean the device only with water
and a soft, damp cloth.
2 Material damage
avoid
Follow this instruction to avoid
material damage and damage to the
device.
PAY ATTENTION!
Incorrect dosage of fabric softeners,
detergents, care products and
cleaning agents can affect the
functioning of the appliance.
▶
Follow the manufacturer's dosing
recommendations.
Exceeding the maximum load
quantity affects the operation of the
appliance.
▶
Observe and do not exceed the
maximum load for each
programme.
The device is secured for transport
with transport locks. Transport locks
that have not been removed can lead
to material damage and damage to
the device.
▶
Before commissioning, remove and
store all transport locks completely.
▶
Before every transport, install all
transport locks completely to avoid
transport damage.
Improper connection of the water
inlet hose can lead to material
damage.
▶
Tighten the screw connections on
the water supply hand-tight.
▶
It is best to connect the water inlet
hose directly to the water tap
without additional connecting
elements such as adapter,
extension, valve or the like.
▶
Make sure that the internal
diameter of the water tap is at least
17 mm.
11
