Troubleshooting
en
45
Fault
Cause and troubleshooting
No water is visible in
the drum.
Water is below the visible area.
▶
Not a fault – no action required.
▶
Do not add any extra water to the appliance while it
is operating.
Drum jerks after the
programme starts.
This is caused by an internal motor test.
▶
Not a fault – no action required.
Residual water is
present in the com-
partment .
Insert in compartment is blocked.
▶
"Cleaning the detergent drawer", Page 35
Vibrations and move-
ment of the appliance
whilst spinning.
Appliance is not correctly aligned.
▶
"Aligning the appliance", Page 15
The appliance feet are not fixed.
▶
Secure the appliance feet.
→
"Aligning the appliance", Page 15
Transit bolts have not been removed.
▶
"Removing the transit bolts", Page 13
.
Drum rotates, water
does not flow in.
Load detection is active.
▶
Not a fault – no action required.
Note:
The load detection can take up to two minutes.
Heavy foam build-up
Detergent dosage is too high.
▶
Immediate measure: Mix one tablespoon of fabric
softener with 0.5 litres of water and pour the mix-
ture into the left-hand compartment (not for outdoor
clothing, sportswear or items stuffed with down).
▶
Reduce the amount of detergent for the next wash-
ing cycle with the same load.
High spin speed not
reached.
A low spin speed is selected.
▶
The next time you run a wash cycle, set a higher
spin speed.
Less Ironing
is activated.
▶
Select the programmes that are suitable for the
type of fabric.
Unbalance load detection system is using a reduced
spin speed to eliminate an unbalance.
▶
Redistribute the laundry in the drum.
Note:
Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
▶
Start the
Spin
programme.
