Siemens WG44G20BDN, User Manual And Installation Instructions

Page: 31 / 52

operation
en
31
3.
Fold the measuring aid down and
click it into place.
4.
Push in the detergent drawer.
13.7 Adding detergent and
care product
Notes
¡
Do not use the measuring aid for
liquid detergent for gel detergents,
washing powder, or if Prewash or
"Ready in" time are activated.
¡
Observe the information about de-
tergents and care products
→
Page 29 .
1.
Pull out the detergent drawer.
2.
Pour in detergent.
→
"Detergent drawer", Page 18
3.
If required, add the care product.
4.
Push in the detergent drawer.
13.8 Starting the programme
Note:
If you want to change the time
until the programme ends, set the
"Ready in" time first.
▶
Press ⁠ .
a
The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a
The display shows either the pro-
gramme duration or the "Ready in"
time.
a
After the programme has ended,
the display shows: "End" .
13.9 Soaking laundry
Note:
No additional detergent is re-
quired. The washing solution is then
used for washing.
1.
Start the programme.
2.
To pause the programme, after ap-
prox. 10 minutes, press
⁠ .
3.
To resume the programme, after
the desired soaking time, press
⁠ .
13.10 Adding laundry
1.
Press ⁠ .
The appliance pauses.
Note:
If ⁠ appears, it is not pos-
sible to add laundry.
When ⁠ goes out, it is possible to
add laundry.
2.
Open the appliance door.
3.
Add or remove laundry.
4.
Close the appliance door.
5.
Press ⁠ .
13.11 Cancelling the pro-
gramme
1.
Press ⁠ .
2.
Open the appliance door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the
Rinse
programme.
– If the water level is high, start
the
Spin
programme or select
a suitable programme for drain-
ing.
→
"Programmes", Page 24
3.
Remove the laundry → Page 32 .