en
Faults and what to do about them
32
Information on the display panel
Faults and what to do about
them
Information
Cause/Remedy
Õ
■
Flashes fast + signal
: The door was opened and the water level is too high.
Close the door, continue the programme with
I
(Start/Reload)
button or
select
Empty
programme.
■
Flashes slowly
: The door lock temperature is too high to open the door. Wait
approx. 30 seconds until the door lock cools down.
Hot
The door cannot be opened after the drying programme due to the high tempera-
ture. The cooling process continues until the display disappears, after which the
door can be opened.
|
■
Flashes
(no water supply): Tap turned on? Water inlet filter blocked? Clean
the water inlet filter.
Water hose kinked or blocked?
■
Lights up
(low water pressure): For information only. This will not affect the
programme progress. The programme duration is extended.
E:18
Drain pump blocked; clean the drain pump. Clean the drainage hose
on the siphon.
E:32
Alternating display with
End
when programme is finished: unbalance problem,
spinning phase is aborted.
E:95
Alternating display with
End
when programme is finished: no water detected in
drying phase, may get bad drying result.
Other displays
Turn the programme selector to
$
Off
. The appliance is switched off. Wait 5 s and
switch on again. If the display is indicated again, call customer service.
Faults
Cause/Remedy
Water is running out.
■
Correctly attach/replace drainage hose.
■
Tighten screw-fitting on the supply hose.
Water not flowing in.
Detergent not dispensed.
■
I
(Start/Reload)
not selected?
■
Tap not open?
■
Filter blocked? Clean the filter
■
Supply hose kinked or jammed?
The washer dryer door
cannot be opened.
■
Safety function active.
Note:
For safety reasons, the washing machine door remains locked
when the water level or temperature is high (See
~
Cancel the pro-
gramme
) or while the drum is rotating.
■
- - - -
(Rinse stop = without final drain/spin) selected?
■
Can be opened with emergency lock release only?
■
Childproof lock active? Deactivate.
