Siemens VS07 series, Instruction Manual

Page: 36 / 127

35
en
Figure
Pet hair tool
Floor tool for easy and thorough vacuuming of pet hair.
Push the telescopic tube into the connecting piece of the
pet hair tool until it engages.
Press on the locking collar and pull out the telescopic
tube to disconnect.
To clean, simply vacuum the tool using the suction
pipe/telescopic tube.
Figure
Hard-floor brush
For cleaning hard floor coverings
(tiles, parquet flooring, etc.)
Connect the floor tool and the telescopic tube together.
Figure
Once you have switched off the vacuum cleaner, you can
use the parking aid on the back of the vacuum cleaner if
you wish to stop vacuuming for a short time.
To do this, slide the catch on the floor tool into the
groove on the back of the vacuum cleaner.
When the work is done
Figure
Unplug the vacuum cleaner.
Briefly pull the power cord and release. The cord rewinds
automatically.
Figure
To store or transport the vacuum cleaner, use the storage
aid on the underside of the vacuum cleaner.
Stand the vacuum cleaner up on its end. Slide the catch
on the floor tool into the groove on the underside of the
vacuum cleaner.
Changing the dust bag and filters
Replacing the dust bag
Figure
If the dust bag change indicator is completely yellow
when the floor tool is lifted from the floor and the highest
suction power is selected, the dust bag must be
changed, even though it may not yet be full. In this case
it is essential to change the dust bag due to the type of
material it contains.
First check that the nozzle, suction pipe and flexible hose
are not blocked, as this would also lead to the dust bag
change indicator being triggered.
Figure
Open the lid by moving the locking lever in the direction
of the arrow.
18
17
16
15
14
13*
12*
Figure
a)
Seal the dust bag by pulling the sealing strip and then
remove it.
b) Insert a new dust bag into the holder and close the dust
bag compartment lid.
!
Caution: the lid will only close when the dust bag is
inserted.
Cleaning the motor protection filter
The motor protection filter should be cleaned regularly by
knocking out the dirt and rinsing.
Figure
Open the dust bag compartment lid (see Figure 18).
Pull out the motor protection filter in the direction of the
arrow.
Clean the motor protection filter by tapping it.
If it is very dirty, the motor protection filter should be
rinsed.
The filter must then be left to dry for at least 24 hours.
After cleaning, slide the motor protection filter into the
vacuum cleaner and close the dust bag compartment lid.
Replacing the exhaust filter
You must replace the exhaust filter in your vacuum cleaner
once a year.
Replacing the micro-hygiene filter
Figure
Open the dust bag compartment lid (see Figure 18).
Release the filter holder by pressing the locking tab in the
direction of the arrow
Remove the foam filter and micro-hygiene filter.
Insert the new micro-hygiene filter and foam filter into the
filter holder.
Insert the filter holder into the vacuum cleaner and clip
into place.
Replacing the micro active carbon filter
Figure
Open the dust bag compartment lid (see Figure 18).
Release the filter holder by moving the locking lever in
the direction of the arrow.
Remove the micro active carbon filter.
Insert the new micro active carbon filter into the vacuum
cleaner and clip into place.
22*
21*
20
19
Innenteil 5100 003 119 A 16.01.2013 10:00 Uhr Seite 35
Downloaded From Vacuum-Manual.com Manuals