GAMMA
instabus
Technical Product Information
February 2010
Blind actuator UP 520/31
5WG1 520-2AB31
Technical Manual
UP 520/31, 4 pages
Siemens AG
Industry Sector, Building Technologies
Update: http://www.siemens.com/gamma
© Siemens AG 2010
Low Voltage Distribution
Subject to change without further notice
PO Box 10 09 53, D-93009 Regensburg
2.10.1.18/4
Æ
Outputs:
A blind actuator is switching an electrical drive, which is
configured for two rotating directions (Up/Down). (cf.
figure 5)
M
L1
L2
L3
N
µ
µ
PK
BN
BK
L
EIB+ / RD
EIB- / BK
A / GN
com / WH
B / YE
com / BN
Prog.
U
n
~
230V
Figure 5
Note
•
The outputs of the blind actuator are electrical
interlocked
V
Danger
•
The soldered end of lines have to connect by using
the attached clamps.
•
Do not connect three-phase AC motors to blind
actuators
•
Observe the instructions of the motor
manufacturers if motors are to be connected in
parallel. Otherwise risk of irreparable damage to
the motors.
•
Use only blinds or shutters with limit switches
(mechanical or electronic). The limit switches of
the connected motors must be checked for correct
adjustment.
Dimensioned picture
Dimensions in mm
Figure 6
Ø = 53 mm
Height = 28 mm
General notes
•
Any faulty device is to be returned to the local Siemens
office.
•
If you have further questions concerning the product,
please contact our Technical Support:
℡
+49 (0) 180 50 50-222 (0,14 €/min. from the German
landline network, deviating mobile communications
prices are possible)
+49 (0) 180 50 50-223
E-Mail: [email protected]
Internet:
www.siemens.com/automation/service&support
