Page
11
Document Number: 0072
Rev. 09
CONTROLLED COPY
6.1.2 ROV Receptacle Cap
The ROV Receptacle Cap can be removed by simply securing the Receptacle via suitable means (if
not already mounted to the structure) and then pulling on the cap. Slots are provided on each side of
the cap to allow finger access and easy removal.
Figure 7 - ROV Receptacle Cap
Refitting the Receptacle cap can be done by simply pushing the cap back into the Receptacle
shroud until the spring plungers engage, locking the cap into place.
6.1.3 Penetrator Cap
Penetrator caps would usually be removed by Siemens Subsea site engineers during the
termination of the Penetrator to the module. It is recommended that only trained personnel remove
Penetrator caps though details are provided here for information only. Penetrators may be supplied
with pre-terminated tails which are sealed with a cable gland. This should be slackened off prior to
removal of the cap. To remove the cap, unfasten the 2 cap head screws using a suitable allen key
and then simply slide the cap off the internal termination of the Penetrator, over the tails.
Figure 8 - Penetrator Cap
Refitting the Penetrator cap is a reversal of the removal procedure.
Secure Receptacle
Connector (if not
mounted to Structure)
Pull on Cap
to remove
Use Finger slots
to pull on cap
If fitted, slacken off
compression nut on
cable gland using
suitable spanner
Unfasten cap head
screws and slide off cap
Summary of Contents for SpecTRON 5
Page 1: ......
