Softening SystemNL
Water hardness °dH
0 - 6
7 - 8
9 - 10
11 - 12
13 - 16
17 - 21
22 - 30
31 - 50
Hardness Range
soft
soft
average
average
average
hard
hard
hard
mmol/l
0 - 1.1
1.2 - 1.4
1.5 - 1.8
1.9 - 2.1
2.2 - 2.9
3.0 - 3.7
3.8 - 5.4
5.5 - 8.9
Set value
H:00
H:01
H:02
H:03
H:04
H:05
H:06
H:07
Remark:Set the device to the
determined water hardness.
With a water hardness of 0 - 6 °dH
you do not need to use softening salt
for dishwashers and you can switch
off the water softening.
†Switching off water softening",
Softening salt
You can soften the water with
softening salt.
Filling softening salt
If the Refill softener salt indicator
lights up, top up the softener salt in
the softener salt reservoir
immediately before the program
starts. The amount of softening salt
required depends on the water
hardness. The higher the water
hardness, the greater the amount of
softening salt required.
Set water softening
Set the device to the water hardness.
1.
Determine the water hardness and the
desired setting value.
PAY ATTENTION!
†Dishwasher detergent can damage the water
damage hardening.
▶
Only fill the water softener
reservoir with dishwasher
softening salt.
†The rinse aid container can be
softening salt for dishwashers
corrode.
▶
To ensure that spilled softening
salt is rinsed from the rinse aid
container, the softening salt must
be filled into the softening salt
reservoir immediately before the
program starts.
2.
Press.
3.
Approx. 3 seconds on
to access the basic settings.
Busy-
aThe display shows H:xx
to give.
aThe display shows
reflected
to give.
4.
Just as often on or
the desired water hardness has
been set.
press until
The factory setting is H:04.
5.
To save the settings, press . for
about 3 seconds
to press.
27
