NLSoftening System
1.
Open the lid of the softening salt
reservoir and remove it.
Switch off water softening
If the refilling salt indicator bothers
you, for example if you use a
combined dishwasher detergent with
a salt component, you can switch off
the indicator.
2.
When using for the first time: fill the
reservoir completely with water.
3. Note:Only use dishwasher
softening salt.
Do not use salt tablets. Do not
use table salt.
Remark
To avoid damage to the
appliance, only switch off the
water softening in the following
cases:
†The water hardness is maximum
times 21 °dH and you use a
combined dishwasher detergent
with salt substitutes. According to
the manufacturer's instructions,
combined dishwasher detergents
with salt substitutes can only be
used up to a hardness level of 21
°dH without adding softening salt.
†The water hardness is 0 - 6
°dH. You do not need to use
softening salt.
Place the softening salt in the
softening salt reservoir.
a
Funnel
1
Fill the water softening salt
reservoir completely with softening
salt. The water in the reservoir is
displaced and flows away.
1.
Press.
2.
Approx. 3 seconds on
to access the basic settings.
Busy-
4.
Fit and close the lid of the
reservoir.
aThe display shows H:xx
to give.
aThe display shows
reflected
to give.
3.
Press repeatedly until the
display shows H:00.
press until
4.
To save the settings, press . for
about 3 seconds
to press.
aThe water softener has been
switched on and the refill
softener salt indicator is
deactivated.
1
Depending on the
device version
28
