36
Fault
Action
Cause
Foam comes out.
Too much detergent.
Switch off the appliance.
Mix 1 tablespoon of fabric softener
with ½ litre of water and add to disĆ
penser II.
Switch on the appliance again.
Reduce detergent dosing for the
next wash cycle.
Motor noise
Not a fault.
Noises may be generated during the runningĆin phase of the drive motor.
Pump noise
Not a fault.
Noises generated when the pump starts up or draws air are normal.
"Lid" button cannot be
pressed.
Programme not ended or "
5
"
selected.
When the water has been drained
and the programme has ended, the
appliance lid can be opened after
approx. 2 minutes.
Vibrations during wash
and spin cycles
Transit bolts not removed
Remove the transit bolts; see
installation instructions.
p
y
Appliance feet not secured.
Secure the appliance feet.
Appliance standing on rollers.
Swivel the lever from left to right.
Repeated spinning
Not a fault.
Unbalanced load detection system attempts to remove an imbalance by
repeatedly spinning the washing.
Programme runs for
longer than usual.
Not a fault.
Unbalanced load detection system
attempts to remove an imbalance
by repeatedly distributing the
washing.
Wash large and small items of
washing together to reduce the
imbalance.
Foam detection function has
implemented an additional rinse
cycle to dissolve the foam.
Adjust detergent dosing for the next
wash cycle.
Washing result not
i f
Soiling is greater than assumed.
Select suitable programme.
g
satisfactory.
Insufficient detergent dispensed.
Dispense detergent according to the
manufacturer's specifications.
