Siemens SIWAMAT XS 424, Instruction Manual And Installation Instructions

Page: 29 / 44

Programme does not
start.
Loading door not closed.
Check whether laundry is trapped in
door.
The  Ready" control
light flashes.
Close the loading door (a click
should be heard).
Programme does not
start.
 Start" button not pressed. Press the  Start" button.
Water does enter the
hid t t i
Water tap not turned on. Turn on water tap.
machine or detergent is
not washed away.
Supply hose kinked or trapped.
not washed away.
The  Active" control
light flashes.
Strainer in supply hose clogged. Clean the strainer
(refer to Page 26).
Detergent in chamber is
not washed away.
A programme without Prewash was
selected.
Select " 60
°
C C
Linens with Prewash".
Water cannot be seen in
drum.
This is not a fault.
The water lies below the visible part of the drum.
Washing solution is not
l l d i d Th
Loose debris is blocking the pump. Clean the pump (refer to Page 25).
g
completely drained. The
 End" control light
flashes.
FluffĆproducing laundry was washed
at a high temperature. The water
drainage pipe or drain hose is
blocked.
Clean the water drainage pipe
and/or drain hose.
Water is flowing out from
underneath the machine.
The thread of the supply hose is not
tight.
Tighten the thread.
Leak in the drain hose. Replace the drain hose.
Foam coming out of the
detergent dispenser.
To much detergent.
Mix 1 tablespoon of fabric softener
with ½ litre / 1 pt of water and pour
into chamber of the detergent
dispenser.
Reduce the amount of detergent
next time.
Repeated spinning at
short intervals.
This is not a fault.
The imbalance compensation system is attempting to balance the load
through repeated spins.