Siemens SITRANS T3K PA, Instruction Manual

Page: 66 / 130

Instruction Manual 7NG3213
66
SITRANS T3K PA
C79000-B7174-C55-04
Different codings for the respective quality specification.
Status coding for ”Poor quality”
Dec Hex Cause Measure
04 04 Parameters do not match. Dynamic
value is incorrect.
Check the parameters.
15 0F Device error detected, e.g. memory
error. The transmitter is switched off
with certain memory errors.
Change the transmitter.
16 10 Connected sensor shows error. Check wiring and sensor.
17 11 Short-circuit detected. Check wiring to sensor.
18 12 Open circuit or sensor break
detected.
Check wiring and sensor.
31 1F
1) 2)
1)
Transmitter out of order. Parameterizable equivalent value behavior.
Three cases can be selected: 1. Through connect parameterized equivalent value.
2. Hold last valid value (default value).
3. Through connect bad value/status
2)
Depending on the parameterization, the transmitter is in a certain state which requires an
adapted procedure:
1. and 2.: The transmitter is out of order. Clear the cause of the error or re-paramterize the
equivalent value behavior and switch the state to automatic.
3. Analyze the bad value/status.
Table 1 Status coding for ”Poor quality”