Siemens SINAMICS GL150, Operating Instructions Manual

Page: 110 / 168

This can be carried out using the addition point for the main and additional setpoint in the
setpoint channel. Both variables are imported simultaneously via two separate or one setpoint
source and added in the setpoint channel.
8.3.2 Direction of rotation changeover
You have the following options of subsequently inverting the phase sequence:
● Replace the motor cable.
● Enter a negative setpoint or change the device parameterization.
Direction of rotation changeover is initiated as follows:
● For control via PROFIBUS using control word 1, bit 11
● For control via the cabinet operator panel (LOCAL mode) using the "Reverse direction of
rotation" button
Note
Only one direction of rotation is enabled in the factory setting.
8.3.3 Suppression bandwidths
Variable-speed drives can generate critical whirling speeds within the control range of the
entire drive train. This prevents steady-state operation in their proximity, that is, although the
drive can pass through this range, it must not remain within it because resonant oscillations
may be excited.
The suppression bandwidths allow this range to be blocked for steady-state operation.
Because the points at which critical whirling speeds occur in a drive train can vary depending
on age or thermal factors, a broader control range should be blocked.
To ensure that the speed does not constantly increase and decrease in the suppression
bandwidth (speeds), the bands are assigned a hysteresis.
Specify a minimum speed in order to block a specific range around the stopped state for
stationary operation.
8.3.4 Speed limitation
Speed limitation can limit the maximum permissible speed of the entire drive train to protect the
drive and load machine/process against damage caused by excessive speeds.
Operation
8.3 Setpoint channel and closed-loop control
SINAMICS GL150 6SL38555UN113KA0Z
110
Operating Instructions Rev.201910281450 EXAMPLE