Installing the Device
2.1 General Procedure
of a tool, lock and key, or other means of security, and controlled by the authority
responsible for the location.
2.1
General Procedure
The general procedure for installing the device is as follows:
Note
The user is responsible for the operating environment of the device, including
maintaining the integrity of all protective conductor connections and checking
equipment ratings. Make sure to review all operating and installation instructions
before commissioning or performing maintenance on the device.
1.
Review the relevant certification information for any regulatory
requirements.
For more information, refer to
.
2.
Unpack and inspect the device.
For more information, refer to
"Unpacking the Device (Page 6)"
.
3.
Mount the device.
For more information, refer to
"Mounting the Device (Page 8)"
.
4.
Connect the failsafe alarm relay.
For more information, refer to
"Connecting the Failsafe Alarm Relay (Page
5.
Connect power and ground the device.
For more information, refer to
6.
Configure the device.
For more information, refer to
"Configuring the Device (Page 20)"
.
2.2
Unpacking the Device
When unpacking the device, do the following:
1. Inspect the package for damage before opening it.
2. Visually inspect each item in the package for any physical damage.
3. Verify all items are included.
Note
If any item is missing or damaged, contact Siemens for assistance.
6
RUGGEDCOM RST916P
Installation Manual, 04/2021, C79000-G8976-1489-01
