Installing the Device
2.2 Connecting the Failsafe Alarm Relay
2. Install the mounting brackets to the top and bottom of the chassis using the
bracket mounting screws. Make sure the screws are hand-tightened.
3. Place the device against the panel and align the mounting brackets with the
mounting holes.
3
12
11
1
Bracket Mounting Screw
2
#6 Screw
3
Mounting Bracket
Figure 2.2
Panel Mounting
4. Using #6 screws of sufficient length (not provided), secure the mounting
brackets to the panel. Use wall anchors (not provided) where required.
2.2
Connecting the Failsafe Alarm Relay
The failsafe relay can be configured to latch based on alarm conditions. The NO
(Normally Open) contact is closed when the unit is powered and there are no active
alarms. If the device is not powered or if an active alarm is configured, the relay
opens the NO contact and closes the NC (Normally Closed) contact.
Note
Control of the failsafe relay output is configurable through RUGGEDCOM RS950G .
One common application for this relay is to signal an alarm if a power failure
occurs. For more information, refer to the
RUGGEDCOM RS950G User Guide
for the
RUGGEDCOM RS950G.
RUGGEDCOM RS950G
Installation Manual, 01/2021, C79000-G8976-1037-06
9
