Siemens SIMATIC NET RUGGEDCOM RMC, Installation Manual

Page: 12 / 38

Introduction
1.3 Required Tools and Materials
State Description
Green Power is on
Off Power is off
LINK/ACT LEDs Indicate the connection status of the fiber optic Ethernet ports.
LED State Description
LINK Green (Solid) Link is established
ACT Green
(Blinking)
Port activity
Power Supply Terminal A pluggable terminal. For more information, refer to:
•
"Connecting Power (Page 11)"
• "Power Supply Specifications (Page 19)"
X-Over Switch Allows the use of crossover CAT-5 cables. For more information,
refer to " Copper Ethernet Port (Page 15)" .
MODE Switch Sets the operating mode for the device. For more information, refer
to "Setting the Operating Mode (Page 9)" .
Communication Ports Receive and transmit data. For more information about the various
ports available for the RUGGEDCOM RMC, refer to " Communication
Ports (Page 15)" .
1.3 Required Tools and Materials
The following tools and materials are required to install the RUGGEDCOM RMC:
Tools/Materials Purpose
AC or DC power cord (16 AWG) For connecting power to the device.
CAT-5 Ethernet cables For connecting the device to the network.
Flathead screwdriver For mounting the device to a DIN rail.
Phillips screwdriver For mounting the device to a panel.
4 x #8-32 screws For mounting the device to a panel.
1.4 Decommissioning and Disposal
Proper decommissioning and disposal of this device is important to prevent malicious
users from obtaining proprietary information and to protect the environment.
Decommissioning
This device may include sensitive, proprietary data. Before taking the device out of
service, either permanently or for maintenance by a third-party, make sure it has
been fully decommissioned.
For more information, refer to the associated
Configuration Manual .
RUGGEDCOM RMC
Installation Manual, 04/2021, C79000-G8976-1006-10
3