Overview
1.2 Design of the device
SIMATIC IPC677D
14
Operating Instructions, 09/2014, A5E32995420-AC
1.2
Design of the device
1.2.1
Operator controls and interfaces
Device with PROFIBUS interface
①
PROFIBUS DP/MPI
fieldbus
PROFIBUS DP/MPI interface (RS 485, isolated), 9-pin sub D socket
②
On/off switch
You switch on the device with the on/off switch. This requires that the
BIOS setup entry "After Power Failure" is set to "Power On".
The on/off switch does not isolate the device from the power supply.
Position "ON", when the "-)" symbol is pressed inward on the device.
Position "OFF" is the factory state.
③
100-240 VAC
Power supply connection
④
2 × Ethernet
•
X1P1, left: RJ45 Ethernet port 1 (exclusive PCI interrupt) with
10/100/1000 Mbps, iAMT capable
•
X2P1, right: RJ45 Ethernet port 2 (shared PCI interrupt) with
10/100/1000 Mbps
⑤
4 × USB
USB 3.0 high current, backward compatible with USB 2.0/1.1
⑥
COM1
Serial interface
⑦
DisplayPort
DisplayPort connection for digital monitor
⑧
DVI-I
DVI connector for CRT or LCD monitor with DVI port
⑨
PCI/PCIe expansion
cards,
COM2/LPT and USB
on expansion card
(optional)
behind the cover
⑩
On/off button
The on/off button has three functions:
•
Switch on the PC: Briefly press once
•
Shut down operating system and switch off PC: Briefly press once
•
Switch off PC without shutting down the operating system (hardware
reset): Press for more than 4 seconds.
Note: The BIOS setup entry "After Power Failure" has been set to
"Power On". This means the device is switched on with the on/off
switch. You then do not need to press the on/off button.
⑪
4 status LEDs
Status display of the operating state
