Configure firmware
2.4 "Advanced" tab
Firmware/BIOS description SIMATIC IPC227G, IPC277G, IPC327G, IPC377G
Operating Instructions, 09/2021, A5E50059883-AB
13
2.4
"Advanced" tab
2.4.1
"Boot Configuration"
Basic display and input options during the boot procedure
Calling "Boot Configuration"
Select: "Setup Utility (Page 11)" > "Advanced" > "Boot Configuration".
Firmware setting Value
Setting in delivery
state
Meaning
IPC227G
IPC277G
IPC327G
IPC377G
Numlock
Off
Numerical keypad is switched off after starting the device.
On
x
x
Numerical keypad is switched on after starting the device.
POST Errors
Never halt on
errors
Continue the booting process when errors occur.
Halt on all
errors
Cancel the booting process when any errors occur
All without
keyboard
x
x
Cancel the booting process if errors occur, except for
keyboard errors.
2.4.2
"Peripheral Configuration"
Configuration of the interfaces.
Calling "Peripheral Configuration"
Select: "Setup Utility (Page 11)" > "Advanced" > "Peripheral Configuration".
Firmware setting Value
Setting in delivery
state
Meaning
IPC227G
IPC277G
IPC327G
IPC377G
Peripheral Configuration
COM Port 1(X30)
Enabled
x
x
Enables the serial port. You can then set the I/O base
address and the interrupt.
Disabled
Disables the serial port. This releases the resources it
used.
Base I/O Address
3F8h/2F8h/3E8h/2E
8h/338h/228h/220h/
238h
2F8h
2F8h The I/O base address is pre-assigned and also
recommended.
Interrupt
IRQ3/IRQ4/IRQ5/IRQ6
/IRQ7/IRQ10/IRQ11
IRQ3
IRQ3
The interrupt is pre-assigned and also recommended.
