Device maintenance and repair
5.4 Replacing the SSD
SIMATIC IPC127E
50
Operating Instructions, 01/2019, A5E44296915-AA
Installing the SSD
To install the new backup battery, follow these steps:
1.
Place the heat sink
②
on the SSD
①
.
2.
Insert the SSD including heat sink into the plug connector.
3.
As shown in the figure, the heat sink must rest on the enclosure. Check the position of the
heat sink by carefully sliding the module back into the enclosure. Correct the position of
the heat sink, if necessary.
4.
Position the spring
③
in the heat sink so that the ring-shaped part of the spring comes to
rest above the screw sleeve; then fasten the SSD again with the screw.
5.
Close the enclosure again. To do so, proceed in the reverse order of the removal.
