Water supply - cold only
Align the machine
Fig.
8
!
The machine must be perfectly level with all
four feet standing on the floor. It must not
rock from side to side.
Use a spirit level to align the machine on all
sides.
If necessary, correct the height of the machine s
feet.
1. Undo the lock nuts.
2. Adjust the height of the feet.
3. Tighten the lock nuts again firmly to ensure
that the feet remain at the same height.
Fig.
19
,
21
,
22
For the water connection a standard cold-
water line with a minimum water pressure
of 0.1 MPa is required (with tap full ON, at
least 8 liters of water must flow out in one
minute). If the water pressure exceeds 1 MPa,
a pressure reducing valve must be added.
!
Never connect the machine to the mixer tap
of a pressureless hot-water heater.
!
Caution! Connections are under full water
pressure; check for leaks with tap turned
fully ON.
!
The filters at the free end of the inlet hose
and at the back of the machine should only
be removed for cleaning purposes.
!
To avoid water damage, the tap must be
turned OFF after using the machine.
!
The plastic nuts on the hose connections
must only be tightened by hand.
The face of the water tap must be free
of burrs and sharp edges.
en
,
21
Summary of Contents for Silver WD 1000
Page 25: ...18 18 5 4 7 6 8 23 ...
Page 26: ...10 11 12 13 14 15 16 17 9 18 24 ...
Page 27: ...20 19 25 21 22 5 4 3 2 1 6 ...
