.
SATURN
Installation Test Procedures
Issue 1, May 1986
Table 6.09 Siemens Digital Telephone
Display Test
NOTES: 1) If
system
flag TSTDIAG has been enabled in the data base or the Siemens Digital Telephone under
test is classmarked with TSTAPP feature, the maintenance test phone is not
to
or
the
Apparatus Diagnostic routines; therefore, perform only steps 5 through 9.
2) If the system option flag TSTDIAG has been disabled in the data base or the Siemens Digital Telephone under
test is not classmarked with the TSTAPP feature, the maintenance test phone is required to enable or disable
the Apparatus Diagnostic routines; therefore, perform the entire procedure (steps 1 through 10).
PROCEDURE
VERIFICATION
IF VERIFICATION
IS NOT
OBTAINED
1
Place maintenance test phone Dial tone is returned.
off-hook.
2
D i a l t h e D i a g n o s t i c T e s t A c c e s s C o d e .
Recall dial tone is returned.
3
Dial 3 to enable the Apparatus
Confirmation tone is returned.
nostic test.
4
P l a c e m a i n t e n a n c e t e s t p h o n e N o n e .
on-hcok.
5
P l a c e t h e S i e m e n s D i g i t a l T e l e p h o n e
Dial tone returned.
under test off-hook.
G
Dial the Siemens Digital Telephone
Recall dial tone is returned. The
If reorder tone is returned, the
test access code.
code is momentarily displayed,
mens Digital Telephone Display Test
then the display unit clears.
is being used, retry later.
7
Depress any button in the Siemens
Groups of 16 of each of the
If verification is not obtained, either
D i g i t a l T e l e p h o n e u n d e r t e s t t o i n i t i a t e
ble characters are scrolled in the
t h e S i e m e n s D i g i t a l T e l e p h o n e o r t h e
test.
s h o w n i n T a b l e 6 . 0 9 . A f t e r t h e
SLMD circuit is defective. Replace
last
(underscore) is
Siemens Digital Telephone with a
(Note: The display test can be sus-
played the following occurs:
good one and retry test. If verification
pended any time by depressing any
is obtained, replace the Siemens
button. The test can be resumed at
tone is returned.
T e l e p h o n e .
any time in the same manner.)
All button
flash and the audible
If verification is still not obtained,
alerting device sounds at intervals.
replace
SLMD PCS.
TEST COMPLETE is displayed.
8
P l a c e S i e m e n s D i g i t a l T e l e p h o n e
hook to terminate test or wait 30 se-
conds for test timeout.
9
If no additional Apparatus Diagnostic
T e s t s a r e t o b e p e r f o r m e d , p r o c e e d a s
follows:
Place maintenance test phone Dial tone returned.
off-hook.
D i a l t h e D i a g n o s t i c T e s t A c c e s s C o d e .
Recall dial tone is returned
Recall dial tone returned.
Dial 2 to disable the Apparatus Diag-
N o n e .
nostic Test.
P l a c e m a i n t e n a n c e t e s t p h o n e N o n e .
on-hook.
G - 2 4
