Siemens RUGGEDCOM RS920W, Installation Manual

Page: 13 / 44

RUGGEDCOM RS920W
Installation Guide
Chapter 1
Introduction
Required Tools and Materials 3
6
1
2
3
4
7
5
4
8
9
Figure 1: RUGGEDCOM RS920W
1. POWER LED 2. ALARM LED 3. EoVDSL Port 4. Wireless Ethernet Ports 5. Serial Ports 6. RS232 Console Port (Serial) 7. Failsafe
Alarm Relay 8. Chassis Ground Connection 9. Power Supply Terminal Block
POWER LED Illuminates green when power is supplied to the device.
ALARM LED Illuminates red when an alarm condition exists.
Console Port The serial console port is for interfacing directly with the device and accessing initial
management functions. For information about connecting to the device via the serial
console port, refer to Section 3.1, “Connecting to the Device” .
Communication Ports Communication ports in general receive and transmit data, as well as provide access to the
RUGGEDCOM ROS Web interface. For more information about the various ports available,
refer to Chapter 4, Communication Ports .
Failsafe Alarm Relay Latches to default state when a power disruption or other alarm condition occurs. For more
information, refer to:
•
Section 2.5, “Connecting the Failsafe Alarm Relay”
• Section 5.2, “Failsafe Alarm Relay Specifications”
Power Supply Terminal Blocks Pluggable terminal blocks for connecting one or more power sources. For more information,
refer to Section 2.6, “Connecting Power” and Section 5.1, “Power Supply Specifications” .
Section 1.3
Required Tools and Materials
The following tools and materials are required to install the RUGGEDCOM RS920W:
Tools/Materials Purpose
AC power cord (16 AWG) For connecting power to the device.