Siemens RUGGEDCOM ROX II, User Manual

Page: 632 / 798

Chapter 13
Unicast and Multicast Routing
RUGGEDCOM ROX II
CLI User Guide
586 Configuring Interfaces for IPv6 Static Routes
• Section 13.12.7.3, “Adding an Interface for an IPv4 Static Route”
• Section 13.12.7.4, “Deleting an Interface for an IPv4 Static Route”
Section 13.12.7.1
Configuring Interfaces for IPv6 Static Routes
To configure an interface for an IPv6 static route, do the following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to
routing » ipv6 » route » {subnet} » dev , where subnet is the subnet (network/prefix) of the
static route.
3. Configure the following parameter(s) as required:
Parameter Description
interface { interface } Synopsis: A string
The interface for the static route.
This parameter is mandatory.
distance { distance } Synopsis: A 32-bit unsigned integer between 1 and 255
The distance for the static route.
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 13.12.7.2
Viewing a List of Interfaces for IPv4 Static Routes
To view a list of interfaces assigned to an IPv4 static route, type:
show running-config routing ipv4 route subnet dev
Where:
•
subnet
is the subnet (network/prefix) of the static route
If interfaces have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing ipv4 route 0.0.0.0/0 dev
routing ipv4 route 0.0.0.0/0
dev switch.0001
no distance
!
!
If no interfaces have been configured, add interfaces as needed. For more information, refer to Section 13.12.7.3,
“Adding an Interface for an IPv4 Static Route” .
Section 13.12.7.3
Adding an Interface for an IPv4 Static Route
To add an interface for an IPv4 static route, do the following:
1. Make sure the CLI is in Configuration mode.