RUGGEDCOM ROX II
CLI User Guide
Chapter 13
Unicast and Multicast Routing
Deleting an Interface for an IPv4 Static Route
587
2. Add the gateway address by typing:
routing
ipv4 route
subnet
dev
interface
Where:
•
subnet
is the subnet (network/prefix) of the static route
•
interface
is the name of the interface for the static route
3. Configure the following parameter(s) as required:
Parameter
Description
distance { distance }
Synopsis:
A 32-bit unsigned integer between 1 and 255
The distance for the static route.
4. Type
commit
and press
Enter
to save the changes, or type
revert
and press
Enter
to abort.
Section 13.12.7.4
Deleting an Interface for an IPv4 Static Route
To delete an interface for an IPv4 static route, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the gateway address by typing:
no
routing ipv4 route
subnet
dev
interface
Where:
•
subnet
is the subnet (network/prefix) of the static route
•
interface
is the name of the interface for the static route
3. Type
commit
and press
Enter
to save the changes, or type
revert
and press
Enter
to abort.
Section 13.13
Managing Static Multicast Routing
Static multicast routing allows network designers to control the flow of multicast traffic by manually adding static
routes to the routing table.
CONTENTS
•
Section 13.13.1, “Enabling/Disabling Static Multicast Routing”
•
Section 13.13.2, “Managing Static Multicast Groups”
•
Section 13.13.3, “Managing Out-Interfaces”
Section 13.13.1
Enabling/Disabling Static Multicast Routing
To enable or disable static multicast routing, do the following:
Summary of Contents for RUGGEDCOM ROX II
