Siemens RUGGEDCOM ROX II, User Manual

Page: 292 / 798

Chapter 7
IP Address Assignment
RUGGEDCOM ROX II
CLI User Guide
246 Managing Address Pools (IPv4)
Section 7.3.11
Managing Address Pools (IPv4)
Address pools define a range of IP addresses that can be assigned to DHCP clients belonging to the same subnet.
CONTENTS
• Section 7.3.11.1, “Viewing a List of Address Pools (IPv4)”
• Section 7.3.11.2, “Adding an Address Pool (IPv4)”
• Section 7.3.11.3, “Deleting an Address Pool (IPv4)”
Section 7.3.11.1
Viewing a List of Address Pools (IPv4)
To view a list of address pools configured for a DHCP subnet, type:
show
running-config services dhcpserver subnet-name name options ippool
Where:
•
name is the name of the subnet
If pools have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config services dhcpserver subnet-name Local options ippool
services
dhcpserver
subnet Local
options
ippool pool1
no unknown-client
iprange 172.0.0.0
end 172.0.0.1
!
option82 class1
remote-id 00:00:00:01:03:01
circuit-id 00:00:00:01:01:01
!
!
!
!
!
!
If no IP pools have been configured, add pools as needed. For more information, refer to Section 7.3.11.2, “Adding
an Address Pool (IPv4)” .
Section 7.3.11.2
Adding an Address Pool (IPv4)
To add an address pool to a DHCP subnet, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the address pool by typing:
services dhcpserver subnet-name name options ippool description