30 / 46
Siemens
RDF300… / RDF340... / RDF400… / RDF600… Basic Documentation
CE1P3076.en
Smart Infrastructure
2020-02-21
The 7-day time clock supports 12 hour and 24 hour format. Select the format while
setting the time clock as follows:
1. Press the
button until the time digits start to flash and then press + or - to
set the time of day. If the current time is in the 24-hour format and you want to
change to 12-hour format, press + passing 23:59 or press - passing 00:00 and
vice-versa to return to 24-hour format.
2. Confirm the time of day by pressing
and the weekday indicator starts to flash.
3. Press + or - to set the current weekday.
4. Confirm the current weekday by pressing
.
In the event of a power failure, the clock stops, but its last time is stored. This time
information is reloaded and starts running after power up. The clock flashes to
indicate that there was a power failure until the time is confirmed by pressing
, or
readjusted by following the above procedure.
4.11 Error handling
When the room temperature is outside the measuring range, i.e. above 49 °C or
below 0 °C, the limiting temperatures flash, e.g. “0 °C” or “49 °C”.
Output Y11 is energized if the current setpoint is not set to “OFF”, the controller is
in heating mode and the temperature is below 0 °C. For all other cases, output Y11
is de-energized. The controller resumes Comfort mode after the temperature
returns to within the measuring range.
In the event of a power failure, all working conditions (operating mode, setpoint, fan
stage, all control parameter settings) are stored without time limitation.
When power returns, the thermostat reloads this data and continues to work in the
same conditions as before.
For thermostats with auto timer refer to section 4.10.
4.12 Infrared remote control
Use the IRA211 infrared remote control to operate a controller with built-in infrared
receiver. The following operations can be carried out remotely:
·
Select operating modes Protection, Comfort or Auto Timer.
·
Adjust setpoint in Comfort mode.
·
Select fan modes Automatic or Manual.
A buzzer in the thermostat indicates remote control command reception.
Infrared remote control can be disabled via parameter P70.
Set the time clock
Power failure
Temperature out of
range
Power failure
